The National 2½" Gauge Association

Keeping the spirit of the past alive for tomorrow and looking to the future
The National 2½" Gauge Association is a not-for-profit organisation



"Helen Longish"

A freelance 4-8-4 Tank Locomotive based on 'Helen Long'by John Baguley

Notes on the Design

Helen Longish came about after someone in around 2009 said that no one would build a loco like this nowadays. I took that as a challenge and designed my own version of the LBSC/James Josslin 'Helen Long'. I used piston valves to the Henry Greenly double ported design instead of slide valves. I also replaced the inside valve gear with the Gresley/Holcroft conjugated valve gear. I lengthened the side tanks as I thought the longer tanks improved the look.This loco was very successful and won the Curly Bowl in 2011.

I had always meant to produce a full set of drawings for this loco and finally have done so. The drawings should be available in the near future. I have made a few changes where I thought the design could be improved but the basic design is as the original. As the original was designed using imperial measurements I have stuck to these as converting to Metric would have meant a complete redesign which I did not want to do. Life is too short!

The full build of the original is described on my website:Helen Longish

Drawings Available

31 sheets of A1 size

Sheet 1 - General Arrangement - Side, Front and Rear Views

Sheet 2 - General Arrangement - Top and Underside Views

Sheet 3 - General Arrangement - Isometric Views

Sheet 4 - Running Chassis Assembly

Sheet 5 - Running Chassis Assembly - Isometric Views

Sheet 6 - Frame Assembly

Sheet 6 - Frame Assembly - Isometric View

Sheet 7 - Frame Plate Details

Sheet 8 - Frame Details 1

Sheet 9 - Frame Details 2 - Wheels Axles and Rods

Sheet 10 - Bogie Assemblies

Sheet 11 - Axle Pumps and Inner Ashpan

Sheet 12 - Cylinder Details 1

Sheet 13 - Cylinder Details 2

Sheet 14 - Alternative Single Ported Valves, Steam and Exhaust Assemblies

Sheet 15 - Outside Motion Brackets and Valve Gear

Sheet 16 - Valve Gear 2 and Lubricator

Sheet 17 - Valve Gear Layout

Sheet 18 - Boiler General Arrangement

Sheet 19 - Boiler Details

Sheet 20 - Boiler Fittings 1

Sheet 21 - Boiler Fittings 2

Sheet 22 - Grate, Ashpan and Smokebox

Sheet 23 - Smokebox Details and Boiler Cleading

Sheet 24 - Running Boards

Sheet 25 - Side tanks

Sheet 26 - Side Tank Details

Sheet 27 - Rear Bunker

Sheet 28 - Cab Spectacle Plate and Cab Roof

Sheet 29 - Removable Cab Details and Injector Water Valves

Sheet 30 - Hand Pump and Whistle

Castings Available

Most of the castings used are from other designs and available from the Association. The original cylinders were fabricated but it may be possible to produce castings if there is a demand for them

This page was last updated on 16/11/2026